Description
Hilway Direct Primo HP, 1 Liter (33.8 oz) protects high-traffic floors with a scuff and scratch resistant top coat on sheet vinyl, LVT, VCT, rubber, linoleum, cork, asphalt tile, marble, slate, concrete, quarry tile or terrazzo floors. Intended for use in busy, commercial environments. More durable than acrylic but less expensive than polyurethane, this polyurethane-acrylic blend floor finish is an excellent solution. The durable field applied floor finish lasts three to six times longer than a premium acrylic polish.
- Also available in 1.33-gallon container
- Ideal for use in high-traffic areas
- Leaves behind scuff- and scratch-resistant layer
- High solids content (42 percent)
- Low VOCs
- Responds well to spray buffing to rejuvenate shine and luster
- Hilway Direct Primo HP Safety Data
- Hilway Direct Primo HP Information
- Hilway Direct Primo HP Instructions
For Use On: Sheet Vinyl, LVT, VCT, Rubber, Linoleum, PVC, Non-PVC, Cork, Asphalt Tile, Marble, Slate, Concrete, Quarry Tile, or Terrazzo Flooring. Test in a small area to check for good adhesion and desired result prior to full use.
Directions For Use:
- Sweep or Vacuum and Clean floor thoroughly prior to application of finish to remove all loose dirt and debris.
- If floor is unfinished, clean floor thoroughly with Hilway Direct Neutral Cleaner or Allsafe Stripper properly diluted or use cleaner recommended by floor's manufacturer then rinse floor thoroughly with water.
- If floor is finished with an acrylic coating, factory or site-applied, finish coating must be removed prior to applying Primo. Unless otherwise specified in flooring manufacturer's instructions, use Hilway Direct Allsafe Stripper diluted 1:5 or 1:10 with clean water as directed on finish remover label. Use an auto scrub or low rpm swing machine with a red scrub pad or equivalent.Rinse floor completely with clean water after removing old coating. Do not let stripper solution dry on floor.
- Shake Hilway Direct Primo vigorously for 30 seconds then let it settle for 5 minutes.
- Floor must be completely dry before applying floor finish. Apply undiluted in a thin, even coat using a microfiber applicator mop. Do not use treated dust mops.
- When first coat is dry enough to walk on (approx 1 hour), apply second coat crosswise.
- Allow floor surface to cure minimum 12 hours before allowing traffic on floor. Some environments will require more drying time depending on ambient conditions including temperature and humidity level.
Coverage: Single Coat: 350 square feet per liter. Proper application requires two (2) coats. Coverage may vary depending on porosity of flooring material.
Recommended Cleaning & Maintenance: Dust mop or sweep then clean with a mop or automatic scrubber using Hilway Direct Neutral Cleaner. Responds well to a spray buff program.