PLUS Floor Finish & Cleaner-Maintainer, 1.33 Gallon (5L)

1 review Write a Review


This versatile, high solids floor cleaner by Hilway Direct - Plus Floor Finish & Cleaner/Maintainer, 1.33 gallon size, is an excellent way to clean, polish, maintain and protect your resilient flooring, including vinyl, rubber, linoleum and more. Hilway Direct PLUS Floor Finish-Cleaner/Maintainer, 5-liter, is formulated with a powerful yet gentle blend of detergents, waxes and polymers for an all-in-one clean and maintain solution. The result is a refreshed surface enhanced with a hard-wearing, acrylic finish that rejuvenates easily with routine cleans and resists scratches and scuffs. This Hilway floor finish may be applied as a finish or as a one-step cleaner and maintainer. Coverage for single coat: 1,500-2,000 square feet per 1.33 gallon container. Proper application requires two (2) coats. Coverage may vary depending on porosity of flooring material.

  • Low VOCs
  • Low-sheen
  • Non-hazardous
  • For use on Vinyl (sheet, VCT, LVT), Rubber, Linoleum, PVC, Non-PVC, Cork, Marble, Slate, Quarry Tile, Terazzo, Concrete, Asphalt Tile


Directions For Use:

Initial Application:

  1. Clean floor thoroughly prior to application of finish. For floors with a factory finish, remove finish following flooring manufacturer's instructions. Rinse thoroughly with water after removing old coating to neutralize.
  2. Shake finish well then let it settle 5 minutes before use.
  3. Apply a thin, even, undiluted coat using a microfiber applicator mop.
  4. Apply 2-3 coats, allowing each coat to air dry completely (approx 30-60 minutes) between coats.
  5. Allow finish to dry for at least eight (8) hours after the second coat and before use.

Daily Cleaning, Mop & Bucket:

  1. Sweep floor to remove loose dirt.
  2. Dilute 1oz Hilway Direct Plus per 1 gallon warm water.
  3. Mop floor with diluted cleaning solution using a 2-bucket system. Use clean water in 2nd bucket to rinse mop.
  4. Pick up excess solution with a tightly wrung-out mop.
  5. Allow floor to air dry. Do not rinse floor after cleaning.

Daily Cleaning, Auto Scrubbing Machine:

  1. Sweep floor to remove loose dirt.
  2. Dilute 1oz Hilway Direct Plus per 1 gallon warm water.
  3. Scrub floor with diluted cleaning solution.
  4. Trail mop excessive wet areas behind scrubber.
  5. Allow floor to air dry. Do not rinse floor after cleaning.


  • Do not use a treated mop for application.
  • When applying the product avoid strong sunlight and drafts.
  • Turn off under floor heat before commencing work.
  • Ensure sufficient ventilation.
  • Read complete product label and manufacturer instructions prior to application.

Extra Information

Normal to heavy traffic
Acrylic Finish/Clean-Maintain
Scratch & Scuff Resistance:
Very Good
Dilutes to Clean & Refresh:
Use as Spray-buff:
Initial Coats:
Solids Content:
Routine Cleaning:
Alternate cleaning cycles with Plus &
Finish Removal:

1 Reviews

  • Posted by Laura Lee on 13th May 2024


    Makes Vinyl "Wood" Flooring Look Amazing

    I used this on my floors 7 years ago and decided it was time for another coat. It brightened it up great. Obviously, it lasts long and is easy to do (just apply to clean floors and let dry 30 mins). I did 2 coats.