SATIN Floor Finish, 1.33 Gallon (5L)

Hilway Direct Satin Floor Finish is a durable, protective floor finish that delivers a mid-range shine on resilient and hard surface floors including sheet vinyl, LVT, VCT and rubber. Hilway Direct Satin Finish, 1.33 gallons, is a non-hazardous, low VOC floor finish that provides excellent wear in commercial or residential environments.

• Satin acrylic finish
• Protects floors against scuffs and scratches
• Non-yellowing
• Low VOCs
• Also available in a 1-liter bottle
• Safety Data: Hilway Direct Satin Floor Finish MSDS
• For Use On: Sheet Vinyl, LVT, VCT, Rubber, Linoleum, Cork, Asphalt Tile, Marble, Slate, Concrete, Quarry Tile, or Terrazzo flooring.
• Coverage: Single Coat: 1500-2000 square feet per 1.33 gallon container. Proper application requires two (2) coats. Coverage may vary depending on porosity of flooring material.
• Print Instructions for Use  &  Product Information Sheet.

Directions For Use:

1. Sweep or vacuum then clean floor thoroughly or remove existing floor finish coating as applicable. Rinse well with clean water to neutralize floor.
2. Shake Hilway Direct finish well before use.
3. Apply length-ways a thin, even, undiluted coat using a wide mop or applicator.
4. When sufficiently hard to walk on, approximately one (1) hour, repeat the procedure crosswise.
5. Apply up to 3 coats total.
6. Allow finish to dry for at least eight (8) hours after the final coat and before use. Finish should be completely dry before allowing traffic on floor.

Notes:

• When applying the product avoid strong sunlight and drafts.
• Turn off under floor heat before commencing work.
• Ensure sufficient ventilation.
• Read complete product label and manufacturer instructions prior to application.
• Dry time will vary depending on ambient conditions including temperature and humiditiy.

Recommended Cleaning & Maintenance: Dust mop or sweep then clean with a mop or automatic scrubber using Hilway Direct Neutral Cleaner.